Une de mes SWM 320 et les autres

[Vous devez être inscrit et connecté pour voir cette image]
swm82[Vous devez être inscrit et connecté pour voir cette image]

belle collection ! j'en profite avec mes problèmes, t'as des grosses billes dans l'embray des swm ?

L'embrayage est le (seul)point faible du rotax,il y a facilement moyen que ce soit un point fort:
1.grosses billes,pas de patte allongée
2.ressorts + souple
3.jouer sur l'épaisseur des disques.
4.cable et levier neufs

Mes embrayages ne collent pas et fonctionnent à 1 doigt (huile Elf pour 2T).

swm82

UN doigt

Oui, un doigt !!!

[img][Vous devez être inscrit et connecté pour voir cette image][/img]

hi hi daccord ta pas interet a recevoir une pichenotte pour un ca ble de smw un doigt... ... trial trial

Or do what i did in the end... Aprilia TXR311 clutch cover. Much easier

The clutch cover SWM with modification for 3 bigest ball 12mm. ref.232.150 and cam ref.259.945.

swm82

I have 2 original SWM side covers and think i will get one modified with the rotax bigger ball bearings and the new lever assembly. If it is as good or better than the Aprilia side cover i will switch over as i prefer the bike to look as standard as possible.

As good with clutch spring 17% more soft (or climber spring).

swm82

Many thanks...
I have lengthened the lever on my Aprilia side cover to give softer feel but now the lever at the handlebar end needs to move a little more.. I do also have the Aprilia Clutch fitted with a lighter weight flyhweel and the extra weight from the other end of crank removed to make the engine a little quicker

I will get my side cover modified soon and compare them against each other for operation and feel.

this is how my clutch cover is at present ..
[Vous devez être inscrit et connecté pour voir ce lien]

Very nice... looks better with the original style side cover.
I will do mine in the next few months... i have just fitted a rear tubeless rim as i do not like tubes and after my knee injury will have to start riding again in the next few weeks.

[Vous devez être inscrit et connecté pour voir cette image][url

Also very nice... i had the mono 311, never a twinshock Aprilia as i was on SWM and then Italjet 350 for short while before several years on Fantics.

Stop Michel, c'est trop

swm82 a écrit:
The clutch cover SWM with modification for 3 bigest ball 12mm. ref.232.150 and cam ref.259.945.

swm82

Where do you get your clutch modification parts from... not available anywhere i have tried here in the UK

You motorcycle on the link find pieces aprilia climber in Italy in this breakage it is necessary to you the crankcase the walnut of clutch and the pine nut(cog) of brace and apres you will have a good clutch
[Vous devez être inscrit et connecté pour voir ce lien]